Answer / sandip upare

Bu using capacitor bank u can increase voltage but not in
that manner and not step up

Answer / sakthivel

capacitor to regulate the ac voltage not increase voltage

Answer / avd

In power system it is practically not possible . But in
electrinics where voltage is less, it can be increased or
decreased by using voltage doubler or devider circuits
respectively.

Answer / deepankar

Yes...
~simply by using
motor-generator set.
~by converting it to dc
and then by using dc
link chopper and then
again converting it to
ac.

Answer / suri

The main purpose of the transformer is to step up and step
down and it is less economical.
By using capacitor bank we can improve the power factor (not
to increase the voltage level)
other conversion device is more loss and less efficiency but
it is possible

Answer / viplav

As 'Deepankar' mentioned above, we can use an MG set to step u voltage

We can also step up using power amplifier circuits, But that involves high amount of power dissipation

Answer / nishant2110

No...its not possible for AC. But we can increase DC
voltage using capacitor bank as mentioned above.

Answer / chirag

yes its possible to increase voltage without transformer by
using capacitors bank .In this bank capacitors are connected
in series like CVT(capacitor voltage transformer).

Answer / aniket jadhav

yes....it's possible to increase the voltage by using the
resistance..b caz when current flow to this resistance ...he
will drop more current for us....that's it.....!

Why annealing is done on transformer core manufacturing process?

1 Answers   ISRO,

what is kvarh? Please define it With calculation General motors ?

1 Answers  

0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz

1 Answers   SoftLogic,

What is cable tray, its type, and its support?

1 Answers  

sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls

1 Answers  

We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks

1 Answers  

what is the meaning and difference between ELECTRICAL DRAWOUT and MANUAL DRAWOUT?

3 Answers  

What is the List of Equipments, Instruments, Components required in Transmission of electricity from 1 substation to other substation(The equipments required in substation too)? What are the differnt IS standrds used for above equipments in Industry?

2 Answers  

what is the difference between star and delta connection ? when we use each one ?what is the best ?

14 Answers   Amara Raja, Daikin,

What is power factor? How to improve Power factor? draw a circuit diagram showing the connection of power factor improvement equipment to the electrical instillation.

1 Answers  

I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?

1 Answers   KCL, MPC,

What is the latest generation of circuit breakers called?

2 Answers   Focus, Oil India,