Answer / rohit

765kv in transmission lines.

Answer / k.prakashchandra

765 KV IS THE 'HIGHEST VOLAGE 'IN INDIA (BIHAR)

Answer / k.prakashchandra

voltage exceeding 650 V and not exceeding 33000 V under
normal conditions as per IE Rules 1956

Answer / k.prakashchandra

This question is a little vague.Hence,there are different
answers.No attempt is done to determine the correct
answer.I am furnishing a few extracts from Rule :2(av) of
IE Rules 1956 regarding the voltages for the benefit of
readers.Voltage means the difference of electrical
potential measured in volts between any two conductors or
between any part of either conductor and the earth as
measured by a suitable voltmeter and is said to
be 'low 'where the voltage does not exceed 250
V ,'medium 'where voltage does not exceed 650 V,'high'
where voltage does not exceed 33000 V, extra high where the
voltage exceeds 33000 V -All under normal conditions
subject to variations allowed by rules , which are 6%,6%,
+6 %& -9%, +10% & -12.5 % respectively.

Answer / rv

765KV is the highest transmission voltage available in
india.
As far as HV and LV are concerned, below 1000v we call it
LV and above 1000v we call it hv i.e. HIGH VOLTAGE..

Answer / h s sandhu

1200KV as displayed by Power grid office

Answer / divya swaroop patel

132kv in transmission lines.

Answer / kaushal

high voltage in india 765kv

Answer / priyank

High Voltage in India is more than 440 volts.

Answer / kapil

400kv is the highest ac transmission voltage in india

What is RMU, and what it's function?

2 Answers  

How to calculate LT Network length in power distribution ? Service cable length considered or not?

0 Answers   Torrent Power,

Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?

0 Answers   Quest,

what is the current setting for different relay protection for transformer .

0 Answers   Crompton Greaves,

for same rating of a transformer and induction motor which one will have higher magnetising current flowing?

2 Answers  

The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s

0 Answers  

difference between moore and mealy model

2 Answers   Google, IBM, TCS,

in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com

0 Answers  

What is float cum boost charging system?

0 Answers  

what is used root two in single phase line?

1 Answers   DVC,

What is the difference between ground & earth or neutral

1 Answers  

What happens if the secondary of the transformer is shorted?

2 Answers