Answer Posted / viplav

As 'Deepankar' mentioned above, we can use an MG set to step u voltage

We can also step up using power amplifier circuits, But that involves high amount of power dissipation

if we give 60 hz single phase supply to the transformer used in europe , than what will happen

1887

---

What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?

2447

---

What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.

2290

---

What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.

1662

---

WHICH SIZE A.B.CABLE IS USED FOR 11KV.

2133

---

I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.

1651

---

Single line diagrams for star to delta and DOL starters.

2206

---

how to identify vector group of three phase transformer by voltage method?

1560

---

Name of the relay of low lub oil presuure in DG sets

1990

---

what is a bus riser in power system and why it is used

46005

---

condition Autotrip facia come on control panel of electrical transmission line?

1516

---

Why two phase welding machine is used instead of three phase welding machine.

1850

---

how does this job compare with others you have aplied for?

1607

---

send me any model test paper of clerical post of state bank of india.......

1786

---

I have experienced electrical maintenance HT ,but I completed be ECE ....can I apply c license or not ???? Pls help me friend s...

1518

---