Answer / pratik patel

well that totally depends upon your requirement.

i.e if only power is your requirment than the Gas turbine
in closed cycle with the HSRG will give you power with less
cost per unit than the steam turbine plant.

but if your primary requirement is steam and secondary is
power than, Steam turbines are choosed. because steam
turbines are provided with certain extractions(for Eg.a 15
MW back pressure turbine with inlet steam of 105 ata
pressure may have extraction of 14 ata, 10 ata and back
pressure of 05 ata) from which you can extract steam at
perticular pressure and supply it for process work(i.e.
steam is required in many process plants). also in back
pressure steam turbines, the left steam at the end of the
turbine after expansion in turbine is also supplied for the
process work also the turbine produces power. This concept
is called Co-generation. i.e. Power is produced along with
Process Steam.

This is the reason that Steam turbines are prefered in
power plant in chemical industries.

Answer / anand swami

thats totaly depends on fuel availibilty And gas based
power plant also inlude hrsg heat recovery steam
generator to run steam turbine.

Answer / kunal kumar saraf

Steam power plant can produce more work work output at any case than gas turbine power plant because the volume handled by a steam turbine is far more than gas compressor.

Answer / abhishek

Work done by the gas turbine is more than the work input to the compressor, in case of rankine cycle, the specific volume of wayer in the pump is much less than that of steam expanding in syeam turbine, soo steam power plants is more popular.

Answer / leela

of course,gas turbine plant runs by fuel and it causes more
polution,efficiency is also less

DURING STEAM BLOWING OF PIPE LINE, A BLUISH COLOR CONICAL PATTERN IS OBSERVED AT THE END OF PIPE. WHATS THE CONCEPT BEHIND IT?

1 Answers  

---

• What are the equipments that you would use inbetween when u have to connect a transformer to busbars?

1 Answers   NTPC,

---

How do gas/electrical/coal heating systems work

1 Answers  

---

min work in a compresor is possible when the value of adiabatic index n is equal to a).75 b)1 c)1.27 d)1.35 e)2 what is adiabatic index.

1 Answers  

---

what is the melting point off gun metal bearing and white metal bearing

1 Answers  

---

What is fuel catalytic cracking

1 Answers  

---

what is pulverisation

3 Answers   NHPC,

---

Is a diesel engines maximum rpm limited by the diesel burn rate?

1 Answers  

---

why not maintain 7.0 ph in boiler ,when 7.0 is not acidic & not basic so why maintain 9+ ph?

4 Answers  

---

How many lubricating holes are there in cylinder?

1 Answers   RRB,

---

A solid body of weight W is placed in a pipe. Suppose water is started flowing through the pipe.what will happen to the body. when it will start flowing ?

11 Answers   BARC,

---

Give the purpose of nozzle in impulse turbine?

2 Answers   ABC Inc, RRB, Siemens,

---