Answer / karthick

minimum work in the compressor is possible only when the
value of index is equal to 1.that represents the isothermal
process.here in this process the compressor operates at low
speed in order to ensure that the temperature should not
increase.

Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb

0 Answers   Saudi Ceramics,

---

tell me about a difficult decision u have made in the last year.

1 Answers  

---

1.an you please send all INTERVIEW Unigraphics/ansys QUESTIONS&ANSWERS. structural analysis,linear,nonlinear analysis,modal,harmonic analysis all questions @answers? Send all typical HR questions &answers?

3 Answers   Kennametal, Sandvik,

---

why we r recommended for pre-action sprinklers @ generator/tx/mv panel room. If any leakage there,that panel will damage. So what is the Logic for pre-action sprinklers there?

0 Answers   DOW,

---

0 1 2 3 4 0 0 0 1 1 2 1 0 0 1 2 3 2 0 1 2 3 4 3 1 1 2 4 4 4 1 2 3 4 5 Horizontal row = x Vertical row = y I need to term these values as a function (yellow horizontal x, yellow vertical as y) The closest I have got is: ROUND(((X*(Y*10+15)-25)/60+1) Is there a way to calculate it?

0 Answers  

---

What are the causes of damage to propellers?

0 Answers  

---

What is method to calculate the noise level at any point of duct if duct dimensions and air flow is known?

0 Answers  

---

The advantage of a controllable pitch propeller?

2 Answers   RRB,

---

what is the stanton curve?

0 Answers   IGCAR,

---

How pipe flanges are electrically insulated?

0 Answers  

---

difference between forced fan and induced fan. principal of cooling tower carbon footprinting stress and strain diagram with whole details types of gesr box pressure with tempeature fall . why cam profile on which pattern stress and bending moment diagram for catilever beam

2 Answers   Engineers India Limited,

---

what is aim?

8 Answers   Atlas Honda, TATA,

---