why steam power plant is more popular than gas turbine plant?
Answer Posted / pratik patel
well that totally depends upon your requirement.
i.e if only power is your requirment than the Gas turbine
in closed cycle with the HSRG will give you power with less
cost per unit than the steam turbine plant.
but if your primary requirement is steam and secondary is
power than, Steam turbines are choosed. because steam
turbines are provided with certain extractions(for Eg.a 15
MW back pressure turbine with inlet steam of 105 ata
pressure may have extraction of 14 ata, 10 ata and back
pressure of 05 ata) from which you can extract steam at
perticular pressure and supply it for process work(i.e.
steam is required in many process plants). also in back
pressure steam turbines, the left steam at the end of the
turbine after expansion in turbine is also supplied for the
process work also the turbine produces power. This concept
is called Co-generation. i.e. Power is produced along with
Process Steam.
This is the reason that Steam turbines are prefered in
power plant in chemical industries.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the purpose of increasing the pressure on the F.O. system of the engine?
Mention two types of dislocations.
what is the relation between pressure&veloscity? give me one practical example?
why r u using enjine oil inside of diesel generaters.what is the uses & why r using diesel by pass filter. plese kindly answer me sir..?
What is the material used ball screw rod
Is critical speed temperature dependent or speed dependent or both?
What is the difference between projectile motion and a rocket motion?
How the thickness of thermal boundary layer and thickness of hydrodynamic boundary layer related ?
Why PWHT IS NOT DONE TO STAINLESS STEEL MATERIAL?
Explain how pipe flanges are electrically insulated?
please send the last 5 years {{{JUNIOR ENGINEER GRADE II - MECHANICAL RRB CHENNAI}}} TECHNICAL question papers
sir i have to face an interview for marine trainee engineer on 15 sept tell me some related questions which r genrally asked...
"In refrigeration, why during operations is running low pressure at the suction side?"
In convection heat transfer, if heat flux intensity is doubled then temperature
What are sleeve and cotter joint?