Answer / sam

Sensors do the actual measurement of a process like
pressure, temperature, vibration, speed ext. This process
measurement is then converted to a proportional electrical
signal and send to the transmitter. The transmitter transmit
this signal again to a distant receiver.
a Instrument can be a combination of both a sensor and a
transmitter or the two can be separate.
Good luck

Answer / chhote lal

We Know that any instruments have three parts
1-sensor
2-transmitter
3-reciever
where sensor taking actual mesurment of process
(temp,pressure,speed etc.)and convert to electrical signal.
and transmitter take o/p electrical signal of sensor and
transmit for reciever with amplitiude.

Answer / abdulbasit137@hotmail.com

sensor is a sensing element like probe , tip, bulb ,
capsule, diaphgram. whos,s sense the pressure, temprature
signal goes to primarym elemant is called transmitter.

Answer / veer tiwari. maintenance engin

sensor is a sensing device...it's sens like
temperature,object,etc so an signal is
generated then this physical signal
converted into an electrical signal..which
transmitted by the transmitter to the
receiver..

Answer / faiyaz ahmad

Transmitter is device which is used to measure physical quantity and sensor is device which is used to sense the physical quantity

Answer / pardeep

The conversion of anlalog physical quantity like temperature and pressure current to current and voltage signal proportional to that measured physical quantity is cal transmitter.
By Pardeep.Kumar
Ranbaxy Lab. ltd. Paonta Sahib.(H.P)

what is electric motorised valve working principle.

1 Answers  

GIVE THE TEMPERATURE RANGE OF PLATIUM RESISTANCE THERMOMETER.

7 Answers   DVC,

what is earthing ,grounding in c&i panel?what is the resistance in earthing and grounding of c&i panel?what do u mean by shielding and what is its resistance?

1 Answers  

Q- voltage source of 12v is driving the circuit.if circut draw the current of 0.5A them source voltage will became 11.8v.what is the power dilevered by source when circuit draw 5A current ?

4 Answers   Ecil,

why 4-20 mA signal is preferred over a 0-10V signal

17 Answers   Sofcon,

why the discharge pressure of ID fan showing negative at fan running condition.(boiler operating condition.)

5 Answers  

There are many type of control cable like pair,core,tried, What are defination each one

1 Answers   Birla,

what should be minimum length and size of impulse line for steam flow orifice and feed water orifice? asked by sanjay parihar

1 Answers   Birla,

what is principal of pressure transmitter?

5 Answers   Hindalco, SPB,

What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...

1 Answers  

Why do we use triad cable for RTD to Temp.transmitter connection? Why we don't use 3 core cable?

1 Answers   Process Control Technologies,

State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.

1 Answers   ADMA OPCO,