Answer / siddhartha jyotishi

resistance should not be more than 2.5 ohms.
shielding resistance is 2Mohm.

if we open the inlet of an air regulator ,how it will affect the out put of regulator? (out put of regulator is using to operate an on-off valve.it is an air to open valve,and valve is in open position.my doubt is air regulator will hold the valve in open or not,if there is no consumption or leak in regulator out put side ,we only loose the input pressure.)

4 Answers   Asian Paints,

---

In RS 500 SLC 5/03 input change one module card to another card, plz. give steps clearly.

0 Answers   BHL,

---

why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?

0 Answers  

---

Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plants instrumentation field , which one field is give long life & which one field is best ,I confused a lot And also I'm studying AMIE, can I choose which field from Section B examination?

1 Answers  

---

centrifugal compressor interlock? Tell me the parameter at which compressor will trip

0 Answers   Cairn,

---

In electronic board one fuse(rating 230v,100ma)showing 2.5 ohms with multimeter,then the fuse is healthy or not.

4 Answers  

---

Full form of KKS when use DCS.

0 Answers  

---

What is offset in a control system.

2 Answers   Sabic,

---

what does ip65 signify??what is its NEMA equivalent???

1 Answers  

---

What is the out put of pressure switch & electronic pressure transmitter.

5 Answers   ADMA OPCO, Al-Barrak,

---

Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure

0 Answers  

---

Which topics are covered in Process Control?

0 Answers   Honeywell, L&T,

---