Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sam
Sensors do the actual measurement of a process like
pressure, temperature, vibration, speed ext. This process
measurement is then converted to a proportional electrical
signal and send to the transmitter. The transmitter transmit
this signal again to a distant receiver.
a Instrument can be a combination of both a sensor and a
transmitter or the two can be separate.
Good luck
| Is This Answer Correct ? | 19 Yes | 2 No |
Post New Answer View All Answers
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
diff between neutral ,ground,phase , earthing and shielding?
how to calibrate corollaries (Mass flow meter)?
what is gas metering system? gas chromatograph? and gas compressors?
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
Describe a time when you anticipated potential problems and developed preventive measures.
what is stroke check for field instument transmetter's & AOV's
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
can you send remote seal interface level transmitter calculation steps for oil water saperator.
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
What is loop1 and loop2 in MTS LT?
