Answer Posted / pardeep
The conversion of anlalog physical quantity like temperature and pressure current to current and voltage signal proportional to that measured physical quantity is cal transmitter.
By Pardeep.Kumar
Ranbaxy Lab. ltd. Paonta Sahib.(H.P)
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
send me last 5 years questions asked in rrb chennai, for section engineer
Questions on flow meters,few questions on HART protocol,
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
plz send me general of ongc
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
What is the Working principle of Dozing valve?
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
any body please send me the old question papers of ongc test.
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
