Answer / dhananjay

A pier is a structure made for intermidiate or end supports
for beams or trusses. it may be of square, rectangular,
circular, or octagonal shape.

Answer / gowri

A pier is a raised walkway over water, supported by widely
spread piles or pillars

Answer / sjtbehera

piers other known as round column.

Answer / rj

Piller (Ex- in compound wall every 5 Mt there will be a
piller made by brick or concret that is pires )

How many fly ash bricks can occupy in one cubic metre ??

0 Answers  

---

What would be the quantity of cement:Sand:Aggregate (1:2:4) requirement for slab casting measuring 1mtr x 1mtr x 0.10 mtr (4 inches)?

1 Answers  

---

A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.

0 Answers  

---

how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???

0 Answers   Student,

---

satart to end steps by step process of building construction...? i want to planning theme accuretly

0 Answers  

---

how much quantity of 1.5" nails and 2.5" nails are required for conventional formwork shuttering?

0 Answers  

---

i have a bar diagram as straigtht bending, but i maked circle bend, how to i justify to others?

1 Answers  

---

For plain cement concrete we want use 20mm aggregate are 40mm mm aggregate

2 Answers  

---

the size of one block is 390mm×190mm×190mm.then how much block will required for 4.6m × 3.4m wall.the thickness of wall is 190mm

1 Answers  

---

1 cu.m contain how many hollow & solid bricks?

3 Answers   L&T, SSC,

---

How much of fly ash is allowable in Portland cement and what is the disadvantage when the level of fly ash is increased?

0 Answers  

---

at the beam-column junction point tell me how much beam bars should pass through column ring ? 3 or 2 or 1 . answer with reason. if it is not happen then what will be he effect ?

1 Answers  

---