Answer / hareesh

The stator of the generator (after synchronization with grid)
is having a rotating emf and the rotor is having its own
magnetic field. If we increase the steam input, the angle
between the stator emf & rotor magnetic field (called load
angle)will also increase due to the additional torque given to
the rotor by the turbine. In that case the power (MW) will
increase. similarly if we reduce the steam input, the load
angle will reduce and the MW will also reduce.

i want all question & answers of the written exam

1 Answers   Essar, L&T, MES, RRB,

---

Where the excitation is given either stator or rotor in actually in power plants?

8 Answers  

---

what is the difference between brushed alternator ,brushless alternator & permanent alternator ?

1 Answers  

---

Hi frnds :) plz tell me that i have 100 KVA 3 phase generator so by thumb rule 100*1.4 = 144 amps and generaly we can operate at 80% load...so it will 144*0.8 =112 amps.... so now i m confused about single phase load.....if we use that generator only for single phase the that 112 amps is total single phase load or i can give 112 amps at red 112 amps at yellow and 112 amps at blue.... i mean that total single phase load that 100 KVA generator will take is 112+112+112=336 amp ??

2 Answers   FWO,

---

what is the calculation of power factor?

4 Answers   GATE,

---

How to find ampere on ht side for selection of cable size ???

0 Answers  

---

what is the difference between induction and synchronous motor?explain in simple words?why 3 phase motor is given preference over single phase motor.

10 Answers  

---

What is the effect if power factor is above 1 or unity.

15 Answers   NTS,

---

if the supply frequency increases what happens to the motor load

2 Answers  

---

77 In constant power region of 3-phase IM torque-speed characteristics, the torque is proportional to A speed B slip C 1/speed D 1/slip

1 Answers  

---

what is reasion of harmonic create the power supply , And how to reduced to harmonic

1 Answers   Turbo,

---

Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend

0 Answers  

---