Answer / jords

it depend on what kind of load.
but the real thing is,
as we increase frequency,the RPM of the motor also
increases.
high frequency can cause motor burning.
low frequency can reduce speed of the motor.

Answer / shinde

Assume motor having torque of 'X' Nm is of frequency 50Hz and voltage of 400V . if the frequency of the motor increased to 60Hz , in order to achieve same torque the V/F ratio should be same in either case. so motor may take more current in higher frequency to achieve same torque.

What are the causes of eddy current losses?

1 Answers   Schneider,

---

What is the difference bet ween EDO Type & MDO type ACBs, and what is the advantage EDO Type over than MDO type ACBs.

2 Answers   Siemens,

---

why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?

0 Answers  

---

i HP = ?? 746 watts or 735.5 and how??

1 Answers  

---

I want to know what is the short circuit level when 8 NOS 2000 kVA, 415v, 50hZ generator connected in paraller

1 Answers  

---

How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?

0 Answers  

---

Can I use RCCB in moisture control device in a submersible pump.

2 Answers   TATA,

---

What happens when ac supply is given as excitation voltage instead of dc supply

1 Answers  

---

A CT is marked as 10VA 0.2FS in its name plate. What is it? Where it is used?

1 Answers  

---

Does power factor vary with speed?If yes, how?If not, why?

4 Answers   Genco,

---

What is the reason behind 11kv 33kv 132kv.....means multiple of 11?

6 Answers  

---

Why 15Amp. MCB is suitable to carry load of 1.5Ton Ac please Explain?

0 Answers  

---