Answer / kaja farkhan

pascal(pa)

Answer / dheeraj

pascal

Answer / murtaza

hi,

it is pascal (pa).

Answer / renjith menon

The SI unit of pressure is N/m2 (Newton per Meter Square). that is called Pa.

Answer / prakash kumar

that is pascle. it is denoted as pa.and its unit is psig.

Answer / s.farhan haider rizvi

that is pascal (pa)

I have a MRE200 amplifier for controlling a mitsubishi servo motor, I would like to know how many pulses are required to rotate the servo motor by 1 degree and what must be the pulse width

1 Answers   Essar,

how to calculate range of Dp transmitter

1 Answers  

What is Trim?

1 Answers   Gujarat Borosil,

how to calibrate steam control valve in steam turbine

0 Answers  

how does pressure is converted into milli amps in pressure transmitter? plzzz explain practically

1 Answers   rsystems,

what is the best method to measuring level in high pressure and temperture thank?

4 Answers  

How to convertion 100 m3/hr to mmH2O or to Kg/cm2?

0 Answers  

what is the difference between Cv and air consumption? why the customer needs Air consumption details?

0 Answers  

What is Burnout feature in a recorder?

1 Answers   CCIE,

Level in tank under vacuum (Ex: Condensate Tank of Power Plant)is measured using D. P. type level transmitter. Tank is subjected to vacuum of 755mmHg. Is it possible to fill wet leg ( i.e. leg connected to top of vessel with low point of D. P. xmtr) with water?. Are there chances of water getting sucked under vacuum? if yes, what is the solution?

3 Answers  

what is protonics how it is differ from electronics

1 Answers  

why we set -10 volt in vibration sensor output,why not +10 volt

3 Answers   Sabic, TVS,