Answer / vaibhav v t

Micro-motion flow meter is usde for mass flow measurement
and it care of your density and temperatre varition while
giving mass flow output.

Answer / mrmk

Used to measure flow and density and it is working in
coriolis principle.

Answer / abdelrahman

I

Is mass flowmeter from EMERSON company and it used for
custody transfer application as it's accurate.
and u can get volume/density and totalizer.
working on the principle of Coriollis theory:
(when amass flows through a vibrating pipe coriollis force
are generated which will bend and twist the pipe these very
small pipe deformations are measured by optimally mounted
sensors and electronically evaluated.
because the measured phase shift of the sensor signal is
proportional to the mass flowmeter.

1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.

0 Answers  

---

Working principle capacitance type level transmitter

3 Answers  

---

Could anybody pls give ans of boiler 3 element control system?

5 Answers   Qatar Petroleums,

---

How is flow measured in square root?

0 Answers  

---

which type inter lock use in petrochemical refinery,and oil & gas?

0 Answers  

---

why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??

1 Answers  

---

please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826

0 Answers  

---

What is transmitter

2 Answers   GNFC, QNFS,

---

what's the reson that,Load is not same on VFD I/P and O/P Side.whenever DOL condition load is same I/P and O/P side.

2 Answers  

---

Tell me about the synchronization panel.

1 Answers  

---

I have one problem for masoneilan displacer type LT.I give some imformation in data shéet given for liquid level range 0 to 600 mm and sg .955 problem is 0% is ok 25%(23%) or 50%(48%)and 75%(73%) and 100% is ok this is up value and down value all ok so please halpe me

2 Answers   Hyundai, TATA,

---

what is the PID controller?

1 Answers  

---