Interested to Buy Any Domain ? << Click Here >> for more details...
what is the si unit of pressure?
- 6 Answers
- 10568 Views
- HTA Instrumentation, I also Faced
- E-Mail Answers
Answer Posted / s.farhan haider rizvi
that is pascal (pa)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
State bernoulli’s application.
How to Calibrate Ultrasonic Level Transmitter in field
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
components of control circuit belongs to control valve
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
what is the process to make control schematic ?
what is piezoelectric transducer?give an example in power plant n state its principle?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
HOW TO CHOOSE FREAQUENCY IN FMCW TYPE RADAR INSTRUMENTS. DESIGN BASIS OR DESIGN CALCULATONS ?
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
