Answer / srinivas kalyan chakravarthy

As material available away from the axis is more(higher section modulus) it can resist for higher degree of forces so I section is preferable

Answer / raghunath

ship has hallow bottom surface nothing inside d bottom
surface that's why ship could floated on water surface

Answer / raghunath

ship has hallow bottom surface nothing inside d bottom
surface that's why ship could floated on water surface

Answer / amrita

i sections have maximum rigidity,and lightness.the bending
of i section is minimum.
ship floats -archimedes principle

Answer / karthick

basically I section have the larger radius of
gyration.radius of gyration is the mass of materials
distributed around the centroidal or neutral axis.so it
gives larger resistance to stress

Answer / jojo

SHIP FLOW'S ACCORDING TO NEWTON'S FIRST LAW
?
LAW OF MOMENT OF INERSIA

Purpose of evaporator in refrigeration system.

0 Answers   RRB, Terram Geosynthetics,

What is a blow down valves?

2 Answers   ABC Inc, RRB, Siemens,

what is the duty & responsibilities of management representative.

0 Answers  

In order to derive the torsional formulas what are the assumptions taken?

0 Answers  

Explain the procedure in staring a F.O. purifier

0 Answers   RRB,

If one cylinder of a diesel engine receives more fuel than the others, then for that cylinder the: a) exhaust will be smoky b) piston rings would stick into piston grooves c) exhaust temperature will be high d) engine starts overheating e) all of the above.

7 Answers   Bhel,

What will happen if head of a selected pump is not utilized in a closed loop water circuit? Flow will increase or decrease or remain same?

0 Answers   ISRO,

what is the use of CW(Circulating water ,clarified water,cooling water),auxiliary cooling water(ACW),auxiliary raw cooling water(ARCW)in thermal power plant.plzz explain the different characteristics of these types of water.

0 Answers   NTPC,

The 4/5th part of volume of a piece of wood is swiming as well as sunk in a fluid. if the relative dencity of wood is 0.8 then what will be the dencity of fluid in KG/M3. PLEASE ANSWER WITH SOLUTION.

2 Answers   Essar,

What is the deff betwen Two stroke engine & Four stroke engines. Difine Theoretcally & Practically.

11 Answers  

I want to model a piezoelectric beam in ansys software.How can I model the electrical circuit and how can I read the general current and voltage produced by the PZ?

0 Answers  

difference between performance and efficiency?

14 Answers