What should be distance required in between two phase of HT cionductors in ope

What should be distance required in between two phase of HT
cionductors in open area??????

Question Posted / shri..

3 Answers
10081 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What should be distance required in between two phase of HT cionductors in open area??????..

Answer / yvbssv prasad

Minimum Distance for HT CONDUCTORS depends upon the kV.If
we consider 11 kV the minimum distance between should be
0.75 mtr in air medium.(and sag should be with in limits).

Is This Answer Correct ?

22 Yes

1 No

What should be distance required in between two phase of HT cionductors in open area??????..

Answer / amarnath

the ideal distance to be maintained is 0.75meters for a HT
Conductor in open area..

Is This Answer Correct ?

3 Yes

0 No

What should be distance required in between two phase of HT cionductors in open area??????..

Answer / ajit

300 meter

Is This Answer Correct ?

2 Yes

23 No

Post New Answer

More Electrical Engineering Interview Questions

what is the concept of star delta starter?

7 Answers

How many methods use the load flow solution?

0 Answers

we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer

0 Answers

In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is

0 Answers Caterpillar,

Dear all, kindly give me the details of leectrical design engineer course details/institute in hyderabad /any where in india.

1 Answers Reliance,

when a three phase motor in running condition consumes 2A in each phase,and if one of the phase gets fails what will be the consumption in other two phases

4 Answers

How to select the Cable size for 550 Amps Load without seeing the cable Catalogue?

8 Answers Nesma,

What is the minimum underground tank size capacity considered for firefighting purpose?

0 Answers

Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.

0 Answers

why transformer is conneted to dc for polarity test.it doesnt work in dc?

1 Answers ABB, KVPY,

why on delay timer used for fully automatic star delta starter?

0 Answers

how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?

0 Answers

For more Electrical Engineering Interview Questions Click Here