Interested to Buy Any Domain ? << Click Here >> for more details...
What should be distance required in between two phase of HT
cionductors in open area??????
- 3 Answers
- 10257 Views
- I also Faced
- E-Mail Answers
Answer Posted / yvbssv prasad
Minimum Distance for HT CONDUCTORS depends upon the kV.If
we consider 11 kV the minimum distance between should be
0.75 mtr in air medium.(and sag should be with in limits).
| Is This Answer Correct ? | 22 Yes | 1 No |
Post New Answer View All Answers
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
i am trying to PSUs/govermeant jobs since last 2 years but still i m not success, plz help me.
working principles of cf lamp,incandescentlamp and f lamp?
how to extend relay operating timing in 24V dc relay card (without using Timer )
Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected
block diagram of 2 ups system connected in parallel mode?
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
in science exhibition how lamp can blink when you clap near the lamp ? thank you
We are designer please help me calculate the size of 11kv cables from step up transformer to M.V panel, total load is 5 mega watt distance 900 feet (used aluminum type cables) please provided formula for calculate the cable with example.
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
How to work meggar?
2. What are the parameters of EHT sub-station?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
I have been using an 600VA with 0.6 p.f UPS with my desktop which has 450W power supply unit. Can anyone explain how can this happen . Because the output of the UPS is 360W (600*0.6) (<450W)
