when turbine trips generator will becomes induction motor or
synchronous motor?
Answers were Sorted based on User's Feedback
Answer / vilas
When turbine trips the generator will become synchronus
motor if the field is present.
Is This Answer Correct ? | 9 Yes | 1 No |
Answer / sudhir singh
on triping the turbine the generator keep runing due to
inertia and have some residual current flowing in it. then
according to law of electomagneti induction that is when a
current carrying conductor is placed in a magnetic field a
force is force is produced dou to which the conductor start
rotating
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / sumit
no ,if turbine trips it is right that bcoz of inertia ,the
generator rotates but it stops after a few minutes and the
generator cum motor gets stationary.but these days we have
the POWER TRAINS in which whenever we have excess of
gases,we can run turbine and then the generator for
electricity purposes......such trains can easily be seen
in POWER STATIONS.
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / atik pathan
If turbine tripps its work as induction motor
Is This Answer Correct ? | 0 Yes | 0 No |
What is the Different between CT Class-0.2 & Class-0.2s ?
why fault current time duration is calculated for 1 minutes?
1 Answers Rockfort Engineering,
how power factor improves by connecting syncronous motor
A circuit breaker on detecting fault will a. Open b. Close c. Open and trigger the alarm
What conditions are required for transformer to operate at low frequencies ?
xlpe cable 4 core nuetral wire is small why ?
what do u mean by starting torque? how it should be for a good motor? what is the relation between starting torque and power factor? What is the relation between efficiency and starting torque?
What are the types of bus duct?
What is the causes Power Factor become leading and what is the effect of Electrical system ?
can we use ordinary transformer in place of autotransformer?give reasons also
any one can explain the stages of a knee point which is taken during ct magnetising curve.
how to check IR values in alternator winding?