when turbine trips generator will becomes induction motor or
synchronous motor?
Answer Posted / sumit
no ,if turbine trips it is right that bcoz of inertia ,the
generator rotates but it stops after a few minutes and the
generator cum motor gets stationary.but these days we have
the POWER TRAINS in which whenever we have excess of
gases,we can run turbine and then the generator for
electricity purposes......such trains can easily be seen
in POWER STATIONS.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
sir pls send the je exam - 2008 and other model question papers..
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
dg earth connect only in the amf panel or not why
What is the limitation of kirchoffs law?
how can we understand that where we have to use ac or dc coil for solenoid valve and why?what is the different between coil of ac and dc explain please.
Did RMU have ct and pt ?
Why we use ups battery and dsdb battery in thermal power plant
How we can calculate the life of Lead acid battery
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
Different types of relay fault which phase sequence??
What is the reason for using a GE G101 MCB in place of an EP102 MCB if both are capable of AC circuit protection?