Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) if the syncronous machine run at leading pf and as its field curret increased its armature current decreased is machine operate as generator or motor?
1 3690in any transimitter (flow/level) there are three terminals for supply& test (+,-,+)in two wire,24VDC given to Tx.,but how 4-20 ma signal travels thru same wire (as it is for 24VDC input supply)?
1 5166Why do we use distinct polarisation (UL-H:DL-V) while uplinking and downlinking rather than same (UL-H:DL-H)?
1 2011
xfhnchncv?
Respected sir please send placement paper of bpcl
i am appearing for the test of NIC SCIENTIC OFFICERS. so please anybody could mail me its placement paper at coolcool.212000@gmail.com
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
send me few previous years section engineer question papers?..
why c is called middle level langauge?
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
hai iam selected in po exam in allahabad bank . my interview date is 02-06-2009. so plese send me some sample question on my email. my email is nitinbikhani@yahoo.com
anyone knows service engineer in chennai for EDM SPARKING MACHINE.CHMER PULSE CD 60 M.pL GIVE ANY CONTACT NOS
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
Which type of question u have asked to the fresher
water leak detection system question & answer
please inform about the date of exam of hpcl for fresh engineers recruitment in mechanical stream?
How to calculate VCB rating for 33KV ,25 MW Power line?