Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) For the calculation of bearing pressure below the footing, to know whether it is below the safe bearing pressure of the soil, the unit of RCC below ground level to be taken is 25 KN/m3 or (25-15)KN/m3, where 25 is the unit weight of RCC and 15 is the unit weight of soil and whether the weight of backfilling to be taken?
2293how the calculation is done if the DG set require for the -- -48 to -51v 4000 ah battery set .
BSNL,
1 4421
Why would you use hydraulics rather than pneumatics?
1.what type of the rock is most suitable for wet mix macadam in construction of road? 2.what is the highest maximum dry density and optimum moisture content can be acheive by using most suitable crush rock?
Why whenever a reciprocating compressor is switched ON or OFF it is put into unloading mode?
How to perform a DC resistance test In Alternator and their proceduces?
what is meant by sustainable developement as far construction field is considered. Give suitable examples to explain the same
can any one please tell me the optionals for group-1 mains.actually i am preparing for civils.i took one optional.
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
How much cum. Brick work can do by 1 madon
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
Why is heat treatment required?
Explain the hooke`s coupling.
Reinforced concrete: suppose you are doing rough estimate for purchase of rebar for reinforced concrete slab for single stores residential building. You know total concrete volume will be 100 m3. How many tons rebar 6, 10 and 12mm will you require for the project?
does a b.tech civil engineer fresher supposed to know how to design rcc structure?
marketing procedure of iocl
Define condensate lift?