how the calculation is done if the DG set require for the -- -48 to -51v 4000

how the calculation is done if the DG set require for the --
-48 to -51v 4000 ah battery set .

Question Posted / sbdandge

1 Answers
4514 Views
BSNL, I also Faced
E-Mail Answers

how the calculation is done if the DG set require for the -- -48 to -51v 4000 ah battery set ...

Answer / k.prakashchandra

Generally ,the charging rate should be at least 10 % of AH
of the battery set numerically,so that full charging time
will not exceed 10 hours.

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

How can we Run three phase motor when only single or two phase supply is available ??

3 Answers

Single line digram for 11 kV to distribution use go,la and do

0 Answers SK,

What is ELCB?

9 Answers Bhel, CDS, IOCL,

After synchronization with grid how to maintain the power factor in lagging or in leading? if lead of lag what is the problem?

3 Answers

What is bushing?

4 Answers

advantages of vvvf drives over non vvvf drives for EOT cranes

2 Answers

why there is 1 phase and 3 phase but not 2 phase and 4 phase?

3 Answers

How to reduce -234126219.6403 MVAr generation and by what?

0 Answers

what happens if we give 1-ph supply for 3-ph Bridge rectifier...??

2 Answers Sanelec,

how to calculate the fault in substation

0 Answers

how to find the ballast lost from the actual wattage? for example i am going to buy decorative type 2x36watts fluorescent light fitting for this lamp how to find the ballast lost? is there any formula?

2 Answers MEIL,

Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed

0 Answers

For more Electrical Engineering Interview Questions Click Here