how many safeties should be present in boiler?what are they?
DN, Nandi, Pump Technology, Siris, Thermax,
4 9209why the steam turbine is not operated in home(base) load more than 1 hour kindly calrify
TATA,
4 8494why high pressure heater will take after sufficient pressure? what happen when high pressure heater will take from COLD REHEAT line at light up time when hp and lp by pass in service.(means can we heater take at low pressure?)
2 3805Post New Power Plant Engineering Questions
What is LB-SR.
How to calculate power press toneage
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
what is restricted earth fault explain in details
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
what is the trip circuit supervision in an electrical meaning?
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
can dp type level transmitter work in under vaccum condition
LAPT working in alternator / generator
dear sir i have completed one year post diploma certificate in thermal power engineering from national power training institute durgapur ...plz suggest me for power sector job
What is difference between secondary Air & Tertiary Air and Their use.?
Looking for Bently Nevada surplus 3300/52-01-00-00 Reverse Rotation Monitor , 4 pieces.
How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....