how will deescribe pile foundation ?
Answers were Sorted based on User's Feedback
Answer / sjtbehera
Pile foundation describe as It is one type of found. which
is apply where soil bearing capacity of soil is less. examp-
sandy soil, river side. Load is transfer via this to hrad
soil.These piles are construct through bore hole whch is
finsh up to hard soil, then concrete those hole upto ground
level.
| Is This Answer Correct ? | 10 Yes | 0 No |
Answer / ramamurthy
Piles are like Columns driven into ground to trasfer load
of super struture to Foundation pile foundation is
neccesary when SBC of soil is less and struture to take
more load. 2 or more than 2 pileas driven over that pile
cap just like footing is going to rest over it and columns
will inbuilt in pile cap for super struture.
| Is This Answer Correct ? | 5 Yes | 1 No |
Answer / muralidhar
piles are deep foundations and used when normal foundation fails and soil is very loose
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / abdul
is apply where soil bearing capacity of soil is less. examp-
sandy soil, river side. Load is transfer via this to hrad
soil.These piles are construct through bore hole whch is
finsh up to hard soil, then concrete those hole upto ground
level.
Is This Answer Correct ? 9 Yes 0 No
0 Sjtbehera
[Hari Machines]
Re: how will deescribe pile foundation ?
Answer
# 2 Piles are like Columns driven into ground to trasfer
load
of super struture to Foundation pile foundation is
neccesary when SBC of soil is less and struture to take
more load. 2 or more than 2 pileas driven over that pile
cap just like footing is going to rest over it and columns
will inbuilt in pile cap for super struture.
| Is This Answer Correct ? | 2 Yes | 0 No |
what is the MSL?where is it located?
2 Answers C-Tech RC Design, Era Infra Engineering, IVRCL,
can any give me bhel n other govt sec interview question
What is hybrid foundation?
what is the quantity of concrete required in 1 cubic meter volume without reinforcement
what is quantity of sand required to plaster wall about 1000 sq ft
What is meaning of Canceled/Flat Beam. What is difference between them? Both type of beam can bear same load if size (width)of the flat beam is increases and depth is same as slab thickness? Kindly suggest to me.
Explination of Expenwion Joints and Construction Joints in Panel casting of Causways?
cement, sand, aggregate,reinforcement & concrete consumption per square feet in multi storeyed building
is it fair to recruit another prestressing agency once earlier agency has provided guide cone for post stressing the Concrete -I girders? It is observed that the bearing plate of another agency is not matching with the earlier one resulting in protruded strands after stressing from the face of girder. Kindly advice.
where we provide hinged joint in a framee structure ?
What is the percentage of steel in 1cu.m. RCC?
How much cum. Brick work can do by 1 madon
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)