Answer / ramadoss

Dear brother ,
digital earth tester containing of four
leads 1. C1
2. P1
3. P2
4. C2
C1 & P1 ARE LINKED WITH A WIRE AND THAT WIRE GOES TO EARTH
PIT ( wich you want to measure )
P-2 ARE CONNECTED TO SPICE ( ROD ) AND 10 MTR DISTANCE IT
SHOULD BE INSERTED
C-2 ARE CONNECTED TO THE SPICE ( ROD ) AND 15 MTR DISTANCE
IT SHOULD BE INSTERTED

AND ON THE DIGITAL EARTH TESTER AND SET THE VALUE IN 200 OHM
SIDE THERE WAS A BUTTON PUSH TO READ WE WANT TO PRESS
CONTUSIONALLY THEN SOME VALUE WAS SHOWN IN DISPLAY

fOR INDIGIUAL EARTH VALUE 1 OHM IS GOOD
FOR COMBINED EARTH VALUE 5 OHM IS GOOD

Answer / mohsen

how digital earth resistance tester works?

Suppose i Have an Ac motor of 25Hp 1500 Rpm 50 Hz Can i run a motor 2500 Rpm by AC drives by increasing a frequency either it safe or not ....

2 Answers  

---

IN A DY11 GROUP DISTRIBUTION TRANSFORMER WITH NEUTRAL EARTHED, WHAT WILL HAPPEN TO THE SYSTEM VOLTAGE & THE EQUIPMENTS IF EARTH GETS OPEN ON LOAD?

2 Answers  

---

TO CALCULATE THE RESISTANCE OF GRR OF HT MOTOR 400KW WHEREAS STATOR VOLTAGE 6.6KV AND ROTOR VOLTAGE 705V AND ROTOR CURRENT IS 346A.

0 Answers   Bhel, NTPC,

---

temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%

0 Answers  

---

What are the steps for Testing of 6.6KV HT Panels?

5 Answers   BSL,

---

What is phase cross over frequency?

0 Answers  

---

What is difference b/w fuse and breaker?

3 Answers   Jindal,

---

capacitor applied voltage is 1100VDC & capacitance value is 82uF how to calculate current of capacitor.

2 Answers  

---

How to calculate meter constant in HT yard pls give me example for this issue

1 Answers   Juniper Networks, MacLellan,

---

if There is Short circuit in Power Transformer, what will happened to Buchholz Relay.?? How Buchholz Relay will respond.??

2 Answers  

---

i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?

0 Answers   Crown Buildtech,

---

Why voltge arev transformed in to 132KV/66/KV/33KV like that

5 Answers   HAL,

---