Answer / parth

In capacitor 2 plate between dielectric medium while capacitor in operation then its fist charge and after some time its discharge.due to the plate while in inductor in which wire turn is use in which flux is charge the indhuctor then as x'mer flux is remain max .whith drow required amount if current form supply and it's continue to connected with the ckt .where in case of capacitor if capacitor charge its contain short path or if remove souce then act like source.

Answer / manoj gautam

Capacitor discharges While Inductor doesn't discharges when put in operation because capacitor leads the current by 90 degree while in inductor current lags by 90 degree.

Answer / k.prakashchandra

Inductor does not store energy

What is VCB'S @ ACB'S.Plz explain Briefly

2 Answers  

---

What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.

0 Answers  

---

what should be correct gas pressures to be a 1.5 ac unite

0 Answers   DDK,

---

ohm's law is applicable to DC/AC/Both??

6 Answers   KPIT,

---

What will be the effect of in HT XLPE 220 KV cable when one side of the Armour/cable ends are not grounded. Will there is difference between 3-phase voltages? like: if A. Both End of Cable grounded Phase Voltages:- V1=219 KV, v2=220 Kv, v3=220 KV. B. One End is grounded other is not: than Impact on Phase Voltages:- V1= KV, v2= Kv, v3= KV. Remain same or unchanged??

3 Answers   Jamshoro,

---

What is the distance between each insulator in 33kv transformer and how can it calculate

0 Answers  

---

List out the the types of Mounting Light fixture?

0 Answers   HLL,

---

hi , i have 150 kw loud and we need 50 m cabil,i want to know wich size cabil we use. thanks

0 Answers  

---

ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture

0 Answers   Mukand,

---

a simple c++ program to calculate simple interst with its data members as private

0 Answers   L&T,

---

we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.

3 Answers  

---

how to test a motor from megger

5 Answers   JSW,

---