What is Generator Protection & Transformer Protection?
Answers were Sorted based on User's Feedback
Generator Protections are:
1. over current protection
2. Earth Fault protection
3. under voltage protection
4. pole slipping protection
5. under frequency protection
6. Impedence protection
7. df/dt protection
Transformer Protections are:
1. Differential protection
2. winding temperature protection
3. Oil temperature protection
4. overcurrent protection
5. Earth fault protection
6. undercurrent protection
Note:
The protection relays are increases deponds on the ratings
of the Transformer and Generator...
| Is This Answer Correct ? | 10 Yes | 2 No |
Answer / parmod kumar
Generators Protection's are
1. over current protection
2. Earth Fault protection
3. under voltage protection
4. under frequency protection
5. Reverse Current Protection
6. High Water Temperature Protection
7. Low Coolent Water Level Protection
8. Over Speed Protection
9. Low Lub Oil Pressure Protection
Transformer Protections are
1. Winding Temprature Protection
2. Oil Temprature Protection
3. Bucholz relay protections
4. overcurrent protection
5. Earth fault protection
6. undercurrent protection
| Is This Answer Correct ? | 6 Yes | 1 No |
Answer / n k singh
Generator protection means protecting the generator in case
any abnormality occurs on generator and transformer
protection means protection of transformer in case any
abnormality occurs on transformer.
General generator protections are:
1.U/F Protection
2.U/V Protection
3.Excitation failure protection
4.Protection against prime mover failure.
General Transformer protections are:
1.Overload protection
2.Ground /Earth fault protection
3.Restricted earth fault protrection
4.Winding temperature high protection
5.Winding protection.
| Is This Answer Correct ? | 3 Yes | 2 No |
why square root 2 is multiplied with line voltage in selection of LA ie 11/sqrtroot3=6.35 kv and it is multiplied with sqrt2 ie 6.35 KV*sqrt2=8.9 kv we will select 9kv.my question is why we are multiplying with sqrt 2?
What are the classification of Servo Motor?
define differential current and restraining current in relays. how to calculate it by mathematically? post the formulaes.
Which device is used for the source of emission of electrons in a crt?
what is the material use in bus bar & why.
it is possible to run 130V AC and 230 V AC cables run in same tray
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
in an ac series circuit there are 30 bulbs are connected in a serial set.what will happen if one bulb is fused and we removed the bulb and reconnect with the remaining bulbs? (29 bulbs). will the brightness of other bulbs increase or not?
what is an alternator & generator
Why we use two wattmeter during block rotor test and no load test of 3phase induction motor? And how can we understand the neat power requirement of from this test?
What is GIS (Gas Insulated Switchgear)
WHAT IS THE DIFFERENE IN ACTION OF MCB,MCCB,RCCB
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)