for a 500 KVA connected load, I calculated 30% of capactor for power correctio

for a 500 KVA connected load, I calculated 30% of capactor
for power correction. Even after using 225 KVR capactor PF
is not improving.
What could be reason for low Phase correction factor?

Question Posted / madhura

0 Answers
2005 Views
Power World, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

what are types of ups?

1 Answers

Can we operate a DG Set in paralell with Transformer ?

6 Answers NDDB, Sobha Developers,

How will you calaculate the Ct ratio based on connected load 500KVA,and 11KV supply ?

3 Answers

we have 3*1 MW generator one NGR is common for all it will be selected during paralle our problem is two generator ca be paralled but when slecting third one we need to close NGR selection on third one other wise voltage not matching why?

1 Answers

Why synchronous motor is used in power factor improvement,dc series in lift

0 Answers

What are the basic components of the feedback control system?

0 Answers

hi friends if you have any 400KV Substation Erection and installations Drgs please send to me.My email id:kandi.suresh441@gmail.com

0 Answers

Mention what are the types of semi-conductors?

0 Answers

transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?

0 Answers Bhel,

EARTH AND NEUTRAL ARE JOINTED OR NOT?

7 Answers

what is the RESTART INHIBIT protection?

1 Answers Thermax,

We use MCCB not MCB for motor starters because MCCBs has capablity to drawout the motor starting current which is 5-6 times the full load current of motor for 1sec. Then why we use SDF in starter panel means MCC panels. Pls reply if any one knows this answer.

1 Answers

For more Electrical Engineering Interview Questions Click Here