we have 3*1 MW generator one NGR is common for all it will
be selected during paralle our problem is two generator ca
be paralled but when slecting third one we need to close
NGR selection on third one other wise voltage not matching
why?



we have 3*1 MW generator one NGR is common for all it will be selected during paralle our problem ..

Answer / k.prakashchandra

To establish relationship between I/C generator and the grid / bus bar/ other two gen through earth

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

WHY WE USE CABLE JUNCTION AFTER BETWEEN TANSMISSION LINE AND TRANSFORMER

1 Answers   L&T,


what are ABCD curves in MCBs and how we observe that curves?

2 Answers  


why transformers are rated in KVA

3 Answers   AITM,


generally rectifying of ac tells. ac signel appear at phase and neutral with respect to frequency by -veand +cycles. but we doesn't experience shock with neutral in house hold ac??????.

1 Answers   ETA, RRR, TCS,


What is pd controller?

0 Answers  






what is the power factor?please tell me uses.

5 Answers   NTPC,


what will happen if the bus PT fuses are accidently removed from the circuit in 6.6kV feeder?

1 Answers  


# 4 hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible my email id is sumit_lig189@yahoo.co.in

0 Answers   HPCL,


What is the difference between security constraint unit commitment and security constraint optimal power flow?

0 Answers   College School Exams Tests,


What is the meaning of STAR POINT? Why this important in CT and VT?

2 Answers   L&T,


7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?

0 Answers  


BRIEFELY EXPLAIN MEGGAR PRINCIPLE

2 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)