Follow Our FB Page << CircleMedia.in >> for Daily Laughter. We Post Funny, Viral, Comedy Videos, Memes, Vines...

I've heard that most of the substations are rated in
multiples of 1.11 because of form factor.What is form factor?

Answers were Sorted based on User's Feedback

I've heard that most of the substations are rated in multiples of 1.11 because of form factor...

Form Factor= R.M.S value / Average value of current
= 1.11

R.M.S value stands for root mean square. It is defined as DC component of ac current which produces heating effect.

 Is This Answer Correct ? 6 Yes 0 No

I've heard that most of the substations are rated in multiples of 1.11 because of form factor...

why it is multiple of 11 means 10% considered as line loss
that why all voltage are in multiple of 11 11kv/33kv/66kv

 Is This Answer Correct ? 2 Yes 1 No

I've heard that most of the substations are rated in multiples of 1.11 because of form factor...

Form factor=RMS VALUE/AVERAGE
VALUE=1.11

 Is This Answer Correct ? 0 Yes 0 No

More Electrical Engineering Interview Questions

How will you Physically differentiate A.C and D.C motor?

how to test and calculat the head and discharge in borewell compressor

15 suspects are rounded by the police and questioned about a bank robbery. Only one of them is guilty. The suspects are made to stand in a line and each person declares that the person next to him on his right is guilty. The rightmost person is not questioned. Which of the following possibilities are true? A. All the suspects are lying. B. The leftmost suspect is guilty. B only

Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?

why is one voltage transformers (instead of three ) installed at the entrence of the incoming line in a substation.

does the transmission line model also requier active power in no-load operation?

why there is a high voltage line in multiplication of 11?i.e.- -66kv,11,kv,22kv

What is the Different Between Breaker and One and half breaker.

We know no of electron and proton in atom but how many Neutron are thire in an atom ?

what is the formular for the calculation of CT'S when installed as part of a electrical installation so the correct meter is used

What are the different parts of Alternator and how it works?

what are the compensations considered while designing a transmmision line.

Categories
• Civil Engineering (5081)
• Mechanical Engineering (4448)
• Electrical Engineering (16620)
• Electronics Communications (3915)
• Chemical Engineering (1093)
• Aeronautical Engineering (214)
• Bio Engineering (96)
• Metallurgy (361)
• Industrial Engineering (258)
• Instrumentation (2995)
• Automobile Engineering (332)
• Mechatronics Engineering (97)
• Marine Engineering (123)
• Power Plant Engineering (171)
• Textile Engineering (575)
• Production Engineering (0)
• Satellite Systems Engineering (106)
• Engineering AllOther (1378)