1.what is meaing of ups,and used in softwares and sud
stations,and main partes in ups.
2.main partes of the Disel Genarator.
3.main partes of the chiller and safty equipments.
Answers were Sorted based on User's Feedback
Answer / baskaran.r
1. UPS means Un-intruptible Power Supply
the main parts are inverter grade thyristors/semiconductor
devices
the out put transfomer
2 field winding, main winding, excitation system
3compressor,gas cooling heat exchanger,expansion valves,
cooling coils, and fan unit
Is This Answer Correct ? | 5 Yes | 0 No |
Answer / thowsif_emerson
1.UPS:_An Uninterruptible power supply (UPS), also known as
a battery back-up, provides emergency power and, depending
on the topology, line regulation as well to connected
equipment by supplying power from a separate source when
utility power is not available.
2.Main Parts of UPS:-Rectifier,Battery Bank&Invertor..
3.Mian Parts of DG:-Radiator,Disel tank,Engine Safety
unit,Batteries,Air,oil&fuel filters&AMF Panel..
4.Main Parts of Chillers
Compressor,Condensors,Blowers,Evaporators,Fan,Cooling
tower..
5.Which Safety Equipments ??????
Is This Answer Correct ? | 5 Yes | 0 No |
why conductors of low tensile strength 1)produce greater sag and 2)can not be used for larger spans
What do you mean by screen of power cables?
What is oscillator circuit?
what is a power factor?
0 Answers MPWU Kiribati, Thermo,
how to enter inverter parameter? without manaual?
Why the earth terminal pin is larger than phase and neutral in three pin plug top>
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
How to generate neutral in DG set?
do we convert single phase line to three phase at minimum cost?
How much the fault level of 11 k.v.,22 k.v., 33 k.v. (in Maharashtra- M.S.E.D.C.L) for calculation of short circuit current & selection of h.t.cable.
why the capacitors works on ac only
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you