I've heard that most of the substations are rated in
multiples of 1.11 because of form factor.What is form factor?
- 3 Answers
- 4203 Views
- I also Faced
- E-Mail Answers
Answer Posted / pugazhenthi
Form factor=RMS VALUE/AVERAGE
VALUE=1.11
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the formula to find out two phase active & reactive power
specific difference of ICT&Auto Transformer
What is EMC filter in VVVF Drive ?
wHAT IS CAPACITANCE LATCHING? hOW TO CALCULATE CAPACITANCE LATCHING? hOW TO SOLVE THE PROBLEM IF CAPACITANCE LATCHING APPLIED?
I have iti elec, 1st aid, and 5 yrs experience in 7.5 mw power plant. Am i eligeble for 11kv license in telangana state..when, how to apply for that.?
How to design pavement quality concrete by using C.R.C.P Method
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
various transmission tower like .,D tower ,K.C.O tower ,C.C.O tower,K.C.R tower ,C.C.R tower ,H.C.O tower in different tons.
How to megger test 11 kV cable and the acceptance IR value
How you calculating the 30 Hp 3 phase AC motor of power what size of cable is used for this motor?
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
what is d check in dg 1500kva
