Interested to Buy Any Domain ? << Click Here >> for more details...
I've heard that most of the substations are rated in
multiples of 1.11 because of form factor.What is form factor?
- 3 Answers
- 5254 Views
- I also Faced
- E-Mail Answers
Answer Posted / vikash
Form Factor= R.M.S value / Average value of current
= 1.11
R.M.S value stands for root mean square. It is defined as DC component of ac current which produces heating effect.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
in 1-phase 230v,how in 3-phase 440v. in each phase in between 230v.
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
how we decide the require size is this for a known current at fuu load?
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
How to reduce the static electricity producing in solvent room? By P.D.Patil BioCon
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
1.What will be stored in online ups EPROM IC?
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
What is meant by RVT and NDR ? expansion and details of it
How to Prepare preventive maintenance shedule of machine tool.
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
