Ferranti Effect says that voltage at the receiving end is higher than that at

Ferranti Effect says that voltage at the receiving end is
higher than that at the sending end. How is it possible?

Question Posted / raghu

4 Answers
8327 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Ferranti Effect says that voltage at the receiving end is higher than that at the sending end. How..

During light load condition at receiving end there is a
shunt cpacitor creat due to this receiving end voltage
increase to sending end voltage.

Is This Answer Correct ?

7 Yes

1 No

Ferranti Effect says that voltage at the receiving end is higher than that at the sending end. How..

Answer / karthik raman.b

due to the capacitive effect it happens the two conductor act as two electrodes and air act as insulating medium and form capacitor this will give leading effect and making this problem

Is This Answer Correct ?

5 Yes

2 No

Ferranti Effect says that voltage at the receiving end is higher than that at the sending end. How..

Answer / sunil guru

the series capacitors are connected at the receiving side in parallel with the load.during light load conditions reactive power leads back the active power and also due to the effect of charging current the receiving end voltage is high than sending end voltage so is called ferranti effect

Is This Answer Correct ?

3 Yes

0 No

Ferranti Effect says that voltage at the receiving end is higher than that at the sending end. How..

Answer / prabhakar

DURING NIGHT TIMES THERE IS LIGHT LOAD,SINCE POWER
CONSUMPTION IS LOW i.e;LIGHT LOAD THE VOLTAGE AT RECEVING
END INCREASES AND HENCE IS GREATER THAN SENDING END.

Is This Answer Correct ?

2 Yes

10 No

Post New Answer

More Electrical Engineering Interview Questions

What is the diffrence between PL Lamps and CFL Lamps

5 Answers

Can motor act as generator (OR) vice versa? explain how does it do please post the answer technically

11 Answers GM General Motors,

How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).

0 Answers

what is a types of short circuit and what is a types of distance protection tests

0 Answers Anna University,

What is the application of Dyn1 and Dyn11 vector group of transformer?

0 Answers

Which. Type of motor used in. Fan

10 Answers Bajaj, HCL,

Our Company's Contract Demand is 110 kVA. We use 12 Capacitors each of 12.5 kVAr Capacity to maintain Power Factor of 0.99. So, what steps should we take so that our Contract demand does not exceed 110 kVA?

1 Answers Jindal,

all 3 current transformers (C.T) are burnt in a L.T Panel - what are the possible reasons

5 Answers

What are the protections for HT Motors?

1 Answers BARC,

What is third harmonic?what is the effect of it?

0 Answers GMR,

why the vfd motor take current high in vfd panel then mcc panel.current in vfd panel=160A in 93%.and mcc panel it shows 130A. (132kw motor)

1 Answers

WHY IS THE SIZE OF HOLE OF THE EARTH POINT IN THE PLUG POINT BIGGER THAN PHASE AND NEUTRAL

7 Answers Jindal,

For more Electrical Engineering Interview Questions Click Here