Interested to Buy Any Domain ? << Click Here >> for more details...
Ferranti Effect says that voltage at the receiving end is
higher than that at the sending end. How is it possible?
- 4 Answers
- 8117 Views
- I also Faced
- E-Mail Answers
Answer Posted / tk
During light load condition at receiving end there is a
shunt cpacitor creat due to this receiving end voltage
increase to sending end voltage.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
What are PLC leader logic program method
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
Draw transformer phasor diagram.(full load,no load)
what are the 4 rules to start the motor?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
what is the role of energy meter in distribution system ?
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
Why is the starting current high in dc motor?
What are the application of filter?
what is the difference between "Rotary bypass isolation switch and Normal bypass switch" pls share indepth techs?
what is the difference between vector scale and vector diagram?
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
