Interested to Buy Any Domain ? << Click Here >> for more details...
Ferranti Effect says that voltage at the receiving end is
higher than that at the sending end. How is it possible?
- 4 Answers
- 8167 Views
- I also Faced
- E-Mail Answers
Answer Posted / prabhakar
DURING NIGHT TIMES THERE IS LIGHT LOAD,SINCE POWER
CONSUMPTION IS LOW i.e;LIGHT LOAD THE VOLTAGE AT RECEVING
END INCREASES AND HENCE IS GREATER THAN SENDING END.
| Is This Answer Correct ? | 2 Yes | 10 No |
Post New Answer View All Answers
What are the different types of LT Cables?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
Why did lightening arrestor solid copper rod head is sharp on mobile tower top?
is the value of inductance depends upon the evalue of thitha in doubly excited machine?
Why hydropower stations are preferred solution for meeting peak loads in grids?
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
How to measure current and voltage in an ELV circuit
Can we use a absolute encoder to show rpm of a motor ? what about the condition when power is off ? what is difference if a incremental one is used ?abanirout@gmail.com
dg earth connect only in the amf panel or not why
What is Long rod insulator and it's applications..? merits over the disc insulator ..?
Please give me a erda placement paper
What is formula calculation size cable wire ?
what is 3rd Harmonics? how it is generated in alternator
can we make a electric generator,which can not use any type of fuel,air,solar,gas,thermal,coal,petrol,etc and able to produce electrical energy (or self electricity generating generator)
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
