The D.C. spark test is applicable to single conductor cable
& assemblies of insulated single conductor cables without
insulation shield,metallic sheath or metalic armor?



The D.C. spark test is applicable to single conductor cable & assemblies of insulated single c..

Answer / Pooja Tripathi

Yes, the DC Spark Test is applicable to single conductor cables and assemblies of insulated single conductor cables that do not have an insulation shield, metallic sheath, or metalic armor. This test helps to ensure that the cable insulation meets the required dielectric strength and will be able to withstand the electrical stresses it will encounter during use.

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

How can we determine or find out the proper size of any cable if nothing is mentioned on it.Calculation of size in Sq.mm???

1 Answers  


How to measure 20 hp motor resitance

1 Answers  


How to calculate or formula to calculate rhe power in 2 phase system ??

1 Answers  


What is the Different between CT Class-0.2 & Class-0.2s ?

3 Answers  


WHAT is the no of starts/hr for 3.3 KV, 300 KW motor. Motor is vertical flange type.

1 Answers   DAE, Siemens,


an amazing situation was faced when an alive distribution panel with 415 volts and carrying almost 200Amps has become short and this metal cubical showing 220 volts against neutral and earth. to redress any confusion i checked the panel with help of single 200watts test lamp which also glowing with max.intensity b/w neutral & metal body of DB. amazing situation is that i hold the DB firmly more than once with necked foot means without insulated shoes but not received any electrical shock. whereas our all running gen sets neutral points also proper grounded and this short DB was completely earthed , this is beyond my understanding . any body explain how is it possible . our running gen set neutral also grounded firmly

1 Answers  


where HT & LT capacitor uses ?

2 Answers   NTPC,


hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly

1 Answers  


how to calculate knee point voltage for pt?

1 Answers   Amec,


1. What is the difference between ac induction motor and ac synchronous motor?

11 Answers  


What is the purpose of Rotor earth fault relay and How to test the Rotor earth fault relay in generators and What is the procedure?.

1 Answers  


sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4453)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)