where HT & LT capacitor uses ?
Answers were Sorted based on User's Feedback
Answer / maprayil
Capacitors are of many types, viz, power capacitors, energy
storage capacitors, microfarad capacitors, surge protection
capacitors etc. From your question, it appears that you
are referring to Power Capacitor. LT capacitors are used
in single phase (230V) or 3 phase (415V) system for
reactive power compensation where the loads are inductive
in nature. As far as HT capacitors are concerned, this can
be of any voltage denomination viz., 11 KV, 22 KV, 33 KV,
66 KV, 132 KV, 400 KV etc. Generally these type of
capacitors are installed on the secondary side of power
transformers.
| Is This Answer Correct ? | 20 Yes | 1 No |
Answer / rajendra
These capacitors are designed for protection of large
rotating machines such as motors & generators. At the time
of over voltage during electric storms produces surges to
electrical equipments connected to system. The voltage
stress between turns of multi turn coil sets a limitation
and surge voltage causes breakdown of turn to turn
insulation resulting in short circuited turns.
| Is This Answer Correct ? | 5 Yes | 4 No |
how can we calculate that how much capacitor is needed for a system to increase the pf?
what is vector diagram in three phase transformer
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
15 Answers Bhel, Sail, Sterling Telecom, TCS,
CAN 50Hz transformer work at 60 Hz power supply? if yes how it is possible?
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
What happens with squirrel induction machines if the ends of rotor conductors are kept open? Explain
Is Transol transformer oil comparable to nynas nytro libra?
what is earth pit , how we can measured it, what earth rods reference
On what principle reluctance motors work?
how to make an earthing certificate
which capacity of RCCB used for five thousand watt electricity load?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)