Answer / k.prakashchandra

If coil ends ( star-delta) are freely available you can
measure easily.If not (the primary windings are in delta )
,measure resistance across any two terminals and multiply by
1.5 to get the resistance of each winding ,which is the same
for the other two, for a healthy motor.If measurements are
done to trace the short circuited winding ,you get the least
reading across it by comparison.

What is breather? why we use it ?

3 Answers  

---

why we ht line cable size small rather than lt cable.

4 Answers   Aster Teleservices,

---

why the neutral point is zero in star connection?

4 Answers  

---

Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT

0 Answers  

---

Why r use in the tap changing x' mer.

2 Answers   L&T,

---

Why in earthing, the earthing plate is put in vertical position? and further what is soft coke that is used in earthing?

3 Answers   Wipro,

---

Why we call cable rating in SQ.mm.If it is 240 SQ.mm how much the diameter possible?is there any calculation ?

4 Answers  

---

How power factor of a transformer is calculated

3 Answers  

---

can we run the home fan both clock and anticlockwise direction

1 Answers  

---

I want to know the standards for earthing system as per IEC, BIS & IEEE.

2 Answers  

---

what is model question rrb junior engineer electrical gr.II

0 Answers  

---

how to calculate the current if i know power in MW and voltage 11kv/415v and also want to know that incoming cables for trnsformer

6 Answers   Daikin, KOC, Reliance,

---