Answer / dranav

Isolation Transformers are used to transform power from an
AC power source to an Equipment or device. Isolation of
power source and power device for safety.
Isolation transformers primary function is isolation of the
source and equipment rather than volatge conversion.

Answer / madhusudhana

Isolation transformer is mainly used to isolate the source
and load networks and it is not built with the intention of
the voltage transformation. In addition, this also filters
out the DC harmonics.

what is capacitor voltage transformer?? how it is different from potential transformer?

0 Answers   NHPC,

---

How electrical power(MW)is varied OF an A.C Generator in response to varying steam input to a steam turbine ?

1 Answers   Hindalco,

---

What is Meant by Load factor in Power plant?

2 Answers   ABB, Electrical,

---

what are the main applications of transistor in non-linear region?

0 Answers  

---

Enlist four components of electrive drives.

0 Answers  

---

how a.c. genarator control power factor when its conected to grid supply by incrising or decresing excitation voltage.

1 Answers  

---

How much UG cable size should i use so as to accomodate a ground + 2floors house. A 1.5ton AC & geysers(2) in each floor with lightings

2 Answers  

---

i am going to attaned the engineer (disign)iterview at HAL please give me duid line

0 Answers   HAL,

---

how calculate busbar size for rated amps, which formula use

2 Answers   Rites,

---

why we use delta connection in transformer

2 Answers   UPPCL,

---

Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above

0 Answers  

---

Hydro P.P. run @ 600 rpm,8pole, Nucler P.P @ 1500rpm 4 pole , ThermlP.P @ 3000 rpm 2 pole.Why this diffrence??? when we can generate electricity @ 600 rpm then Why we had incresed speed in NPP & TPP???

3 Answers  

---