Answer / glenn saldanha savio

SINCE BOTH FIELD AND ARMATURE ARE CONNECTED IN SERIES THE
TORQUE EQUATION IS T=KI2. (TORQUE PROPORTIONAL TO SQUARE OF
CURRENT).
ALSO NOTE THAT FROM THE CHARACTERISTIC IT IS THAT AS SPEED
INCREASES THE TORQUE DECREASES AND VICE VERSA.
THEREFORE THE TORQUE IS HIGH ONLY AT LOW SPEED.

Answer / ajay k mathew

in a series motor same high current flows through the field winding and armature,therefore high starting torque

Answer / utkal mishra

we know in series motor t=flux*armature current
as flux directly propertional 2 armaturecurrent

What is the major differences between RCCB & ELCB? If we use ELCB of less sensitivity why does it trip often and can we control it from tripping?

1 Answers  

---

When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number

0 Answers   TATA,

---

Hi, I've just got into my electrical engineering course and I need some help with a question of mine here. During a site visit, we were shown a main LT panel which has switchgears, ammeters and different kinds of relays and the distribution network from that panel. In the main LT panel I've noted down the current readings as Ir - 163A, Iy - 150A and Ib - 147A. The Line to Line voltage is 415 V at 50 Hz and Line to Neutral voltage is 230V at 50 Hz. From the above details, how would I calculate the kVA rating of transformer? The primary side voltage of the transformer is 11 kV and the secondary side voltage is 415V and the frequency is 50 Hz.

2 Answers  

---

For polarity test on a 11/3.3kV 2.5MVA delta-star Unit Auxiliary transformer,415V 3-phase supply was applied at the HV. Connection between Aa was made with a 2.5mm cable. As soon as power was switched on the cable caught fire and burnt. This test was then abandoned. It is noteworthy to say that a similar cable was also used in a similar transformer for the same. The cable did not burn and test was successfully completed with good result. What is wrong? Please, help me out.

3 Answers  

---

What is the function of PMG in DG sets & how it works??????????

2 Answers  

---

Advantages of using bundled conductors ?

3 Answers  

---

When steam condenses and becomes water at the same temperature, the specific heat for the process in kJ/kg k is

0 Answers   Caterpillar,

---

Iin ESP why positive is grounded ? why not negative ?

0 Answers  

---

how it can be decided what will be the rating of CT and PT to be used in LT or HT cables?

3 Answers  

---

why farmers are use earthing instead of neutral for their light conec. at field.is it safe

2 Answers   Honeywell,

---

hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly

0 Answers  

---

what is the correct format to create a resume for interview??

0 Answers  

---