Answer / aamod tripathi

BY USING TWO SECONDRIES

there is a power transformer 66/11kV in delta-delta connection has 5 feeder coming out from the secondary side. One of the feeder in it normally loaded (loaded than other feeder)and this feeder usually trips with double OCR causing the bank transformer to trip. Now if the load of this feeder is put on other transformer then that no problems occurs on that transformer or the load. However normally all the test(IR, PI, short ckt, open ckt,grounding test and other ) has been conducted for this but evertything transformer..... I am not geting what is the actual problem...

2 Answers  

---

Why we use circular(Stepped) cross section in transformer core?

0 Answers  

---

What will happen if i connect two 3-phase tranformers secondary supply on one bus bar that is R-Y-B-N?

2 Answers   GMR,

---

Wht ar the reason for low voltage on consumer side?

6 Answers  

---

what type of current supply is given to house holds?

7 Answers  

---

when will cause the negative sequence falut in electrical system?

2 Answers   Schneider,

---

why voltages are added when batteries are connected in series?

4 Answers  

---

1000 W bulb takes 4.16 Amps at 240 volt then what will be the KWH & if i am using 1000 W bulb at 180 Volt the amps will be 5.55 then what will be KWH????????????????

2 Answers  

---

how to reduce earth resistance in sandy soil.

1 Answers  

---

How can maintain our H.T. motors used in cement plant. please send me procedure.

0 Answers  

---

why the transformer secondary voltage is more than the load end voltage like t/f 11KV/433V for 415V(terminal voltage)

4 Answers  

---

What is harmonics and how the 1st,2nd,3rd etc harmonic levels

2 Answers  

---