Need help. 3 phase system. Neutral line arced and melted upon connection of

Need help. 3 phase system. Neutral line arced and melted
upon connection of connector with 3 phase power. Why would
that happen?

Question Posted / pink

4 Answers
6729 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Need help. 3 phase system. Neutral line arced and melted upon connection of connector with 3 pha..

Answer / gova

Hi
question not clear.Please give more detail

cheers
gova

Is This Answer Correct ?

2 Yes

0 No

Need help. 3 phase system. Neutral line arced and melted upon connection of connector with 3 pha..

Answer / pinky

I have a connector that connects to a piece of equipment.
The connector has many pins mostly for monitoring signals
coming from the equipment and for supplying 3 phase to the
eqpt. When I connected the connector to the equipment it
blew up. The neutral line melted into the piece of
equipment. Why did the neutral line blow.

Is This Answer Correct ?

0 Yes

0 No

Need help. 3 phase system. Neutral line arced and melted upon connection of connector with 3 pha..

Answer / virendra

Pinky,,

be clear what kind of equipment , what is a supply voltage,
the singnal voltage etc.

so that the ans would be givan

Is This Answer Correct ?

0 Yes

0 No

Need help. 3 phase system. Neutral line arced and melted upon connection of connector with 3 pha..

Answer / francisjohn

Check the neutral wire is loose condact

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

what happen if the parallel generator phase angle shift by 1 degree in manual mode

0 Answers EEEC, MEC,

what's burden resistor, why it's used?

1 Answers Bhel, TVS Group,

why full load voltage is less than no load voltage?

4 Answers

What is switching over voltage?

1 Answers MEIL,

what are the ''pitting rings''and how cn they be controlled in a series generator

0 Answers

What is mean by hormonics?

5 Answers

What is the comparision (advantages / disadvantages) of 110V, 60 Hz system to 230 V, 50 Hz system.

2 Answers

Are same transformer be employed for step up and step down services?

3 Answers

what is high pot test on 11kv switchgear and how to apply high voltage on panel what is spheare gap and how to determine its celeberation.

1 Answers

what is MAR

1 Answers NCC,

What is meant by Guard relay ?

2 Answers

How can we Run three phase motor when only single or two phase supply is available ??

3 Answers

For more Electrical Engineering Interview Questions Click Here