Interested to Buy Any Domain ? << Click Here >> for more details...
Need help. 3 phase system. Neutral line arced and melted
upon connection of connector with 3 phase power. Why would
that happen?
- 4 Answers
- 6356 Views
- I also Faced
- E-Mail Answers
Answer Posted / pinky
I have a connector that connects to a piece of equipment.
The connector has many pins mostly for monitoring signals
coming from the equipment and for supplying 3 phase to the
eqpt. When I connected the connector to the equipment it
blew up. The neutral line melted into the piece of
equipment. Why did the neutral line blow.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
along with technical test papers
how the characterstics of control valve being done
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
Difference between drift current and diffusion current?
Can I use star delta connected induction motor for dual supply voltage?
how to calculate cooling requirement of datacentre from electrical load?
A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?
What are the different types of controllers?
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
why power factor is important?
What happen when change order of CT in GIS feeder?
What is the distance between each insulator in 33kv transformer and how can it calculate
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
