1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?

0 Answers  

---

How RTCC works with OLTC

1 Answers   Siemens,

---

when we increase load , current drawn from source also increases why ?

5 Answers  

---

name the famous power plants present in A.P

1 Answers   Power Grid,

---

can any tell me how to do wiring connection in L&T 3ph 4wire E301 CT operated energy meter, what is P1,P2,P3,P0. M1,M2,M3, L1,L2,L3.

2 Answers   Bhartiya International,

---

on what factor insulation resistance depends

2 Answers   Uttam Sugar,

---

Why should The rating of 11 kV DO Fuse is in mulyiple of hundred(200 Amp. 40 Amp, etc) Ampere wheareses the its fuse elemnt has rating in just few Amp (< 12 Amp)? ( Is it jusy beacuse of factor of safty).

1 Answers  

---

What is phase angle? and what is importance to measure it?

2 Answers  

---

In a 3 phase system a neutral exists so that any unbalanced currents can flow through it towards earth.... but a phase demands a particular current as per the load attached to it....then where does the extra current come from the goes in the neutral??....I mean in an unbalanced system a phase demands a current as per its load attached....then where does the unbalanced current come from??

1 Answers  

---

what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).

0 Answers  

---

why motor burns ?

5 Answers  

---

what is difference between Motorised MCCB & ordinary MCCB?

4 Answers   TCL,

---