Need help. 3 phase system. Neutral line arced and melted
upon connection of connector with 3 phase power. Why would
that happen?
- 4 Answers
- 4992 Views
- I also Faced
- E-Mail Answers
Answer Posted / gova
Hi
question not clear.Please give more detail
cheers
gova
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How REF protects transformer alone? explain with diagram.
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
what is meant by brushed alternator & its working principle ?
STATE WORKING OF VACCUM CIRCUIT BRAKER?
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
Why do not we prefer non conventional sources of energy to conventional sources?
ELECTRICAL DRIVES: can a motor load system with passive load torque can have equilibrium speed in second quadrant
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
What is advantages of VSCF wind electrical system?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Load transfer in 11kv double busbar switchgear - operation.
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
what is a synchronizing lamp ?
What is the control action?
