While testing the value of the resistance for the earthing
rod, two auxillary rods are connected to the earthing
tester.What is the working function of a earth tester?
No Answer is Posted For this Question
Be the First to Post Answer
what is FS cable?? Difference between FS and FRLS??
super position theorem is applicable to
sir what is the minimun earth resistance value of an industial bit and grid bit ? and Why?
what is difference between multimeter and transmitter
Why do we use copper cable for HT Supply and why not Aluminium?
What are the possible causes if load is not same on all the three phases
what is a tri vector meter? what are the tri vectors?
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
3. What is Impedance Voltage in Transformer?
16 Answers KESC, L&T, Torrent Power,
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
why we use end termination xlpe cable on ht kit
If UG power cable both ends are to be earthed or what? If not why?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)