Interested to Buy Any Domain ? << Click Here >> for more details...
which type of starter is suitable for single phase motor ?
- 11 Answers
- 16885 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / deepankar
Generally there is no
need of starters for
single phase motors
because they have
very low inertia.
Only an over volt
relay or fuse of
required rating near
main switch should be
suitable.
However if there is no
economical problem
then d.o.l starter may
be used.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Name one of major transformer company in KSA ?
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
how to design the heater in temperature control unit to heat 50KL of water?
Explain using drawings what is reverse PID action w.r.t PID controllers.
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
full form of flry b
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
How to find ampere on ht side for selection of cable size ???
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
how to calculate magnetic force genrated by a coil ?
how to electrically make connection to ferroli GN2N?
